Introduce Myself & Please Help re Stalling Problem

[Cueball]

82 Barometric pressure (BARO) sensor, in ECM - incorrect signal ECM

I think maybe that the other list is the petrol error code list.

[paulanthony]

Thank you for responding. Maybe the list sent by nrg is for the petrol engine as that is the code given for Crank Shaft Sensor and not Barometric Pressure.

I now wonder whether the other codes listed (15 & 18) are correct.

Do you have a list of codes for the diesel engine that you would be prepared to share?

[Cueball]

They are on the wiki site.
See thread for details.
viewtopic.php?f=10&t=3170

But here are code 15 and 18

15 Fuel quantity adjuster position sensor - circuit malfunction Wiring open/short circuit, fuel quantity adjuster position sensor
18 Fuel quantity adjuster/position sensor - malfunction Wiring, supply voltage, fuel quantity adjuster/position sensor, ECM, fuel injection pump

[paulanthony]

Hi All

Further to my stalling issue I have now replaced the crankshaft sensor.

I had to buy a brand new one from Nissan in the end - cost about £106!!

The fault has now pretty much gone. I have found that it needs a little rev from cold before loading the engine otherwise it will still do it.

Otherwise it is OK.

I want to thank everyone who had input (especially NRG & Cueball) for their help and suggestions leading to this diagnosis.

I really love the vehicle.

Paul

[jimbob]

ile go with whot nrg said,had same prob with mine couple of years ago it was fuel injector pump, i presume yours is fly by wire pump

[bigbob_swindon]

jimbob how did you resolve your problem?
I've been told many times that it's my fuel pump and then they follow on by saying " good luck getting that one fixed"!

I too have the codes for the Fuel quantity adjuster position sensor.

[jimmyrev3]

hi bigbob my name has now changed to jimmyrev3 had probs loggin on and with computer,anyway i replaced my pump with second hand one off ebay and bin fine for couple of years now