Nissan Largo Friends

Ahh, brilliant. Mate I used to work for came through with his skip wagon & wouldn't take any cash either in the end! winner! Did look a bit strange though, they must have thought I was scrapping it! Well we're home now & I've stuck a good battery in, given the engine a good run up to temperature, put it through D-N-R-N-D, lock to lock on the steering and managed to make it stall 3 times total, 2 when cold & once just as I was thinking it wasn't going to do it hot! Ahh well.

Very happy with her so far, lots of work to do before MoT (tony, you're correct no T&T but fortunately it's a cat D write off so no VIC needed). Also there's a fair bit of oil round the "A" plate so that's coming out & getting a clean & new gasket shortly. Anyway here's the first couple of pics of "the lardarse" as someone called it! What you all think, worth 2 ton for a diesel 4x4 SXG tintop with all but one set of rear seats missing?

I think you're onto a winner there, new light and wing and a scrub up and she'll look great.

Did you air separator A plate have a gasket behind it? Maybe just not tightened up enough.

Hi m8 good luck with bus and if you want to get some dosh back someone on here is after roof bars

Cheers fellas, I think the roofbars will be staying as I'm not sure but think they may be drilled into the roof! :S I'll put a pic up of the mounting.
I've pulled the grille, airbox & bonnet to improve access and managed a good evenings works getting the old wing, infill panel & headlamp out, pulling the inner wing & slam panel roughly back in line (pretty much matches the offside now & headlamp slots in nicely so should be OK) and tomorrow is the day for tidying up the job & giving it a good coat of primer & underseal. All went fairly well except the lowest wing bolt snapped (thought it would when the head was rusted down to a 9mm haha!) and the fact that I didn't realise the infill panel was that far gone. But I'll take a hit on that for the bonus of it being 4x4 & everything working including the telescopic parking beacon on the bumper! Anyway heres a few pics...

Oops forgot to put the roof bar pic on with them... here it is. And as a further bonus, I found the rear aircon remote in it's slot! oh and it's a soft close door... winning!

Stuck in already I see How is the metal beneath the wing? Survive the impact?

lol yeh couldn't help myself! the inner wing was a bit mangled & it'd pulled the slam panel down but it's come back into shape nicely and tomorrow I shall be putting the wing itself on the lawn & jumping up & down on it like a madman to see if I can't make it at least refittable & passable for MoT in case a decent replacement in the right colour doesn't show up... To be fair I'd put up with a small dent or a frilly arch if someone had one they were throwing out in the same colour.

Right got some free time so off to the garden we go, STOP.... Hammer time!

Sledge hammer m8 lol then get an airarsole spray to finish

lol @ airarsole, that's what I get when I eat chips cheese & beans! Well the wing's bashed into a shape that's acceptable for the moment, will be ok with a skim of filler when we get a dry day, till I get a replacement lined up of course... Just given the air separator a good clean (and what I could scoop out of the plenum too), it was ridiculously filthy. Also took a moment to disconnect the EGR for now. Might blank it at some point but I think it's sealed ok anyhow as the pipe didn't get warm when I ran the engine this time
Full speed ahead towards getting the headlight & tyres now and then off to the MoT man to see what the verdict is...