Nissan Largo Friends

82 Barometric pressure (BARO) sensor, in ECM - incorrect signal ECM

I think maybe that the other list is the petrol error code list.

Thank you for responding. Maybe the list sent by nrg is for the petrol engine as that is the code given for Crank Shaft Sensor and not Barometric Pressure.

I now wonder whether the other codes listed (15 & 18) are correct.

Do you have a list of codes for the diesel engine that you would be prepared to share?

They are on the wiki site.
See thread for details.
viewtopic.php?f=10&t=3170

But here are code 15 and 18

15 Fuel quantity adjuster position sensor - circuit malfunction Wiring open/short circuit, fuel quantity adjuster position sensor
18 Fuel quantity adjuster/position sensor - malfunction Wiring, supply voltage, fuel quantity adjuster/position sensor, ECM, fuel injection pump

Hi All

Further to my stalling issue I have now replaced the crankshaft sensor.

I had to buy a brand new one from Nissan in the end - cost about £106!!

The fault has now pretty much gone. I have found that it needs a little rev from cold before loading the engine otherwise it will still do it.

Otherwise it is OK.

I want to thank everyone who had input (especially NRG & Cueball) for their help and suggestions leading to this diagnosis.

I really love the vehicle.

Paul

ile go with whot nrg said,had same prob with mine couple of years ago it was fuel injector pump, i presume yours is fly by wire pump

jimbob how did you resolve your problem?
I've been told many times that it's my fuel pump and then they follow on by saying " good luck getting that one fixed"!

I too have the codes for the Fuel quantity adjuster position sensor.

hi bigbob my name has now changed to jimmyrev3 had probs loggin on and with computer,anyway i replaced my pump with second hand one off ebay and bin fine for couple of years now