Page 2 of 2

Re: New with stalling problem. Help!

Posted: 30 Aug 2012, 19:18
by neilloop
Tried a few different ways. Will try this way it again. Does engine need to be warm & do you push wire into plug or just touch connections? Can you bridge before ignition goes on?

Re: New with stalling problem. Help!

Posted: 30 Aug 2012, 20:21
by N.r.g
From memory ignition on then bridge for 2secs then pull out n count flashes on dash. Five long flashes is 5. Five short flashes is 5 which gives you code 55. It will keep cycling this sequence untill you turn ignition off.

Re: New with stalling problem. Help!

Posted: 30 Aug 2012, 21:19
by neilloop
tried a few combinations! Do you need to push the wire in to plug or just touch the conections. Does engine need to be warm?

Re: New with stalling problem. Help!

Posted: 31 Aug 2015, 21:16
by Ricie1180
have the same problem it almost feels like the TC is locking up and stalling the car but when I am going along the motorway it does not seem to lock out overdrive, overdrive still comes in but it does not seem to lock out with the extra little rev change, did you ever sort this problem?