Page 2 of 3
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 08:22
				by Cueball
				Welcome to the forums.
Cueball from Pembrokeshire
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 10:32
				by skeatesy
				hi welcome to the forum,mike in somerset
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 11:56
				by davidjgardner
				Thanks for the comments!!
But how do you go up from 14" with just 4 lugnuts??  I thought 15's on up had 5...
Also, they couldn't do an alignment on the van because they need to use the model to calibrate their computers...and since there's no Largo listed they said 'computer says no' 
Perhaps I should be opening a thread on this? This is really just my hello nice to be here threat, non?
 
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 11:56
				by davidjgardner
				Cueball wrote:Welcome to the forums.
Cueball from Pembrokeshire
Thanks so much, Mike!
 
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 11:58
				by davidjgardner
				davidjgardner wrote:Cueball wrote:Welcome to the forums.
Cueball from Pembrokeshire
Thanks so much, Mike!
 
Sorry, I meant Cueball!
David.
 
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 11:59
				by davidjgardner
				skeatesy wrote:hi welcome to the forum,mike in somerset
Thanks Mike!
 
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 15:09
				by gixxerboy
				there is a thread on here somewere about wheel alignment im sure.as for wheel sizes,if you increase the size of the wheel you decrease the hight of the tyre so the wheel and tyre stand the same height.i wouldn't worry about the 4 stud pattern because as long as there tight then there wont be any problems.
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 16:16
				by Smudge
				If you really set your sights on a set of wheels that are 5 stud you can always buy spacers that change from 4 nuts to 5 

Something like these

 
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 26 Aug 2011, 18:11
				by Cueball
				Wheel alignment is toe in 4mm 

 
			 
			
					
				Re: Canadian Largo Hello and Question!
				Posted: 27 Aug 2011, 10:53
				by skeatesy
				hi, welcome to the forum,mike, (polar express) in somerset,england, where are you from in canada?